Telemetric Documentation
DNP-RTM
Enables wireless communications between DNP3 based IEDs and either utility SCADA systems or the Telemetric web site.
Datasheet
User Manual (PDF, 346K)
IED Integration Guides
T646 MicroRTU
Wireless monitoring and control device with six digital inputs, four analog inputs, and six digital outputs.
Datasheet
Technical Specification
User Manual - Rev H Board
(PDF, 563K)
User Manual - Rev F Board
(PDF, 511K)
TVM3, TVM1 Voltage Monitor
A low-cost line voltage monitor for single-phase or three-phase power. It reports power outages, line voltage fluctuations, present voltage status, and monitors the CBEMA Curve.
Datasheet
TVM3 User Manual (PDF, 323K)
TVM1 User Manual (PDF, 320K)
TC012 Capacitor Bank Monitor and Control
An application-specific configuration of the general purpose T646, the TC012 is configured to monitor and control fixed or switched capacitor banks.
Datasheet
Technical Specification
User Manual (PDF, 388K)
T200/1000 MicroRTU
Multi-channel monitoring devices with no control functionality. They operate from 12 VDC power.
Technical Specification
T1000 User Manual (PDF, 321K)
T200 User Manual
(PDF, 307K)
SCADA-Xchange
Software that translates data from the MicroRTU or DNP-RTM into DNP3 and then communicates it to the utility's SCADA system over a secure TCP/IP connection.
Datasheet
NOC and Intelligent Web Server
The Telemetric Network Operations Center (NOC) houses the Intelligent Web Server, a suite of Internet-based applications that enable monitoring and control of remote assets from any Internet-connected PC in the world.
Datasheet
User Manual Archives (previous Telemetric models)
Note: Adobe Acrobat Reader is required to view these documents. Click Here
to download it for free. To view a document click on the link. To download a document, right-click on the link and select "Save Target As..." Some of the files are large, so they may take some time to load. |
